The irrigation micro
spray tube is a porous water spray tube produced by laser or mechanical
drilling. The spray width of the micro-spray tube changes with the
working pressure, and the relationship between the pressure and the
spray width is shown in Photo.
The
micro spray tube of each group of 3 water outlets, 5 water outlets or
more water outlets are directly laid on the ground, and the direct flow
of water in the air can form a micro-sprinkling effect similar to
drizzle. It is a relatively advanced irrigation technology. Its
advantages are firstly to save water. Sprinkler irrigation basically
does not produce deep leakage and surface runoff, and the irrigation is
relatively uniform. Generally, it can save 30% to 50% of water. In the
sandy soil area with strong water permeability and poor water retention
capacity, water saving can be 70%-80%. Secondly, sprinkler irrigation
can improve the conditions of corn growth and development, and once
again, the fertilizer device is attached to the micro-spraying system,
and the fertilizer is treated with irrigation. Spraying water together
not only saves fertilizer, but also improves fertilizer efficiency and
saves labor for labor, thereby saving labor costs and improving the
effect of medication. Sprinkler irrigation has a small amount of water
per plant, which is not easy to damage the structure of the soil, so
that the corn roots grow with a good soil environment. Sprinkler
irrigation can increase the humidity of the air and reduce the
temperature. In addition, when the water temperature is lower than the
temperature, the sprinkler can also warm the water in the air, thereby
increasing the ground temperature. Conducive to the growth and
development of corn. Main size: 28mm, 32mm, 50mm.
Precautions
for the use of micro sprinkler tubes 1. Before laying the microspray
tube, the pests (such as cockroaches) in the soil should be removed with
drugs to prevent them from harming the crops and biting the micro spray
tube. 2. When laying, the micro-spraying hole should be facing up and
the tail should be blocked. Then use a water pump to squeeze the water.
The water inlet is wrapped with gauze (filter) to prevent the hole from
becoming clogged. In case of blockage, untie the tail and rinse it with
water for one minute. Use hand and other tools to gently tap the wall.
3. In the first use, according to your pump pressure, micro spray
tube working length, first open the switch, it is best to open a few
switches to prevent the micro-spray blasting caused by excessive
pressure. If the pressure is not enough, turn off a few switches. The
next time you use the switch, you will know. If the piece is tested
after the water is changed, turn on the switch first, then turn off all
the switches that have been tested to prevent blasting caused by
improper use. 4. When changing the sputum, first squeeze the micro-spray
tube with water pump, wash it, roll it up, put it in a cool place, and
prevent the mouse and other things from biting, so that it can be used
again next time.
Baoding Anyou Industry Co.,Ltd
Irrigation system manufacture
www.anyouirrigation.com
www.ayirrigation.com
